Introduction: Why Your Tariff Band Matters More Than You Think
You top up your prepaid meter with the same amount as your neighbour, but your units finish faster. Or your area is on a band that promises many hours of light, yet you spend most evenings in darkness. In Nigeria, that difference is often not luck — it is your tariff band.
The Nigerian Electricity Regulatory Commission (NERC) groups electricity customers into service bands based on how many hours of supply their area receives. The higher your band, the more you pay per unit of electricity, because you are supposed to get more hours of light. If you are placed on a band that does not match the supply you actually get, you quietly pay more for less.
This guide walks you through four practical steps: confirming your meter is registered and active, finding your tariff band, understanding what that band means for your bill, and escalating if you believe the classification is wrong. Tariff rates, band definitions and complaint channels change from time to time, so always confirm current details on the NERC website and your distribution company’s (DisCo’s) official channels.
What NERC's Tariff Bands Actually Mean
NERC’s banding system, introduced under the Service-Based Tariff (SBT) arrangement, ties what you pay to the quality of service your area receives. Bands are labelled A to E. Band A represents the highest service level — the most hours of daily supply — and attracts the highest rate per kilowatt-hour (kWh). Band E represents the lowest service level and the lowest rate.
The logic is simple: if your area gets more hours of light, you pay more per unit; if it gets fewer hours, you pay less. The bands are meant to reflect the actual supply your feeder receives, not the type of meter you use or the size of your house.
Below is a simple table showing how the bands generally map to service levels. The exact hours and rates are subject to NERC reviews, so fill in the current figures from NERC’s latest tariff order or your DisCo’s tariff page.
BandService level (minimum daily supply)Relative rate per kWhBand AHighest (around 20 hours or more)Highest; typically not subsidisedBand BSecond highestLower than Band A; partially subsidisedBand CModerateLower stillBand DLowSubsidisedBand ELowestMost subsidised
Note: The exact number of hours attached to each band and the current approved rates differ by DisCo and are revised periodically. Always confirm with NERC’s current documentation or your DisCo.
Before You Start: What You Need
Have these details ready before you begin:
- Your meter number (usually printed on the meter itself).
- Your account or customer number (on your recharge receipt or bill).
- The name on the account.
- The name of the DisCo serving your area (for example, Ikeja Electric, Eko DisCo, AEDC, etc.).
- The phone number registered with the DisCo.
- Your most recent recharge receipt or bill, if you have it.
Having these on hand will save you time whether you check online, on your meter, or by calling customer care.
Step 1: Confirm Your Meter Is Registered and Active
Before you worry about your band, make sure your meter is properly registered to your account and is a genuine, NERC-approved meter. An unregistered, bypassed or tampered meter can show misleading information and may not reflect your true classification.
How to confirm:
- Check your DisCo’s customer portal or mobile app. Many DisCos allow you to enter your meter or account number and see your account details, including meter status. The exact portal address and steps differ by DisCo — confirm on your DisCo’s official website.
- Call your DisCo’s customer care line. Have your meter and account numbers ready. The correct phone numbers are published on each DisCo’s website and may change, so verify before calling.
- Visit your local DisCo office or service centre if you cannot confirm online or by phone.
If your meter is not registered, resolve that first. A meter that is not properly linked to your account can cause problems with billing and band classification later.
Step 2: Find Your Tariff Band
This is the core step. There are several realistic ways to find your band. Use whichever is available and convenient for your DisCo.
Route A: Check your DisCo’s website or customer app
Most DisCos now provide a band-check tool on their website or app. You typically enter your meter number or account number and the system displays your band and tariff. For example, Eko DisCo provides a feeder information page where you enter your account or meter number to see your band. The exact web address and layout differ by DisCo and can change, so always start from your DisCo’s official website.
Route B: Check your prepaid meter display
Some prepaid meters show tariff or band information in their display menu. Press the button or use the menu to scroll through the readings. Note that not all meters display the band, and the menu path varies by meter make and model. If you cannot find it, do not assume you are unclassified — use another route.
Route C: Call or message customer care
Call your DisCo’s customer care line or send a message on their official social media channel. Provide your meter number and account number and ask them to confirm your current tariff band. Keep a record of the response.
Route D: Check your recharge receipt or bill
Your most recent recharge receipt or bill may state your band or tariff rate. Look for a line that mentions ‘Band’ or the rate per kWh. If it is not there, use one of the other routes.
Note: The exact USSD codes, menu paths and portal steps vary by DisCo and are subject to change. Always verify with your DisCo’s official channels.
Step 3: Read Your Meter Display Correctly
Prepaid meters display various readings, and it is easy to misread them. Common readings include:
- Units remaining (the balance on your meter).
- Total units purchased since the meter was installed.
- Current tariff or rate (not always shown).
- Meter number and other technical details.
The band is not always shown on the meter itself. A missing band on the display does not mean your meter is unclassified. Also, the specific display codes and button sequences vary by meter make and model. If you are unsure what a reading means, check your meter’s user manual or ask your DisCo.
Step 4: Match Your Band to the Supply You Actually Get
Your band comes with a promise of minimum daily supply hours. If your area consistently gets less than that, you have grounds to question your classification.
Here is a simple self-check:
- Keep a daily log for one to two weeks. Note the date, the time the light came, and the time it went off. A simple notebook or phone note is fine.
- Calculate the total hours of supply per day.
- Compare your average daily hours with the minimum hours your band promises. For example, Band A is generally associated with around 20 hours or more per day, while lower bands promise fewer hours. Confirm the exact hours for each band from NERC’s current documentation.
- If your area consistently receives significantly fewer hours than your band promises, document it. This record will be useful if you need to complain.
Remember that supply can vary due to outages, maintenance or other factors. Look for a consistent pattern over time, not a single bad day.
What to Do If You Think Your Band Is Wrong
If your band does not match your actual supply, follow this escalation ladder:
- Raise a formal complaint with your DisCo. Contact customer care by phone, email or through their portal. State clearly that you believe your band is wrong and provide your meter number, account number and your supply log. Ask for a complaint reference or ticket number and write it down.
- Follow up in writing. If you do not get a satisfactory response, send a written follow-up (email or letter) referencing your ticket number. Keep copies.
- Escalate to NERC. If the DisCo does not resolve the issue within the stated window, escalate to NERC’s customer complaints channel. NERC has forum offices that handle disputes. The exact phone numbers, email addresses, portal URL and resolution timelines change, so confirm them on NERC’s official website before submitting.
- Keep records. Save all receipts, screenshots, ticket numbers and dates. A clear paper trail strengthens your case.
Important: Do not stop paying your bills while a complaint is pending unless you have written confirmation from the DisCo or NERC. Non-payment can lead to disconnection.
Common Mistakes and Myths
- Myth: A higher band always means a better deal. It depends on actual supply. If you pay Band A rates but get Band C hours, you are overpaying.
- Myth: Your band is fixed forever. Bands can be reviewed and changed, especially if supply conditions change.
- Myth: Changing your meter changes your band. Your band is based on your area’s service level, not your meter type.
- Myth: Your neighbour’s band applies to you. Even on the same street, different feeders or service levels can mean different bands. Always confirm your own band.
- Mistake: Not keeping records. Without receipts and ticket numbers, it is harder to prove your case.
Summary: Know Your Band, Protect Your Bill
Your tariff band directly affects how much you pay for electricity. To protect your bill: confirm your meter is registered and active; find your band through your DisCo’s website, app, meter display, customer care or receipt; compare your band to the supply you actually get; and if it is wrong, escalate with records.
Tariff rates and band definitions are reviewed periodically, so always verify current details on the NERC website and your DisCo’s official channels. Keep your receipts and ticket numbers — they are your evidence if you need to complain.